Find the most up-to-date version of DIN at Engineering Buy DIN () Action On Structures – Part 4: Wind Loads from SAI Global. 1 Answer. Steve Blumenkranz, Mechanical Engineer. Answered Feb 5, · Author has k answers and m answer views. Here –> DIN-Deutsches Institut .
|Published (Last):||3 November 2009|
|PDF File Size:||11.28 Mb|
|ePub File Size:||5.11 Mb|
|Price:||Free* [*Free Regsitration Required]|
Please keep in mind that you must already enter the final distributed load here and not the velocity pressure which is always multiplied by an aerodynamic coefficient. In case of doubt decide for the more disadvantageous terrain category.
Apart from the glass it is also possible to restrict the deflection of the beam spans separately for mullions and transoms. Finally you have to determine the wind zone and the terrain category inland or coastal area which match your job.
It is mainly used for buildings which exceed a height of 25 m above ground level. The most commonly used limit values are already suggested. The maximum permissible stress values of different glass types are specified in the lower part of the form.
Wind Load Calculation
It is assumed that the load is constantly distributed over the building width and depth, i. The second calculation method of DIN Deflections of beams and glass panes are not regulated by DIN standards, general technical approvals or application guide lines.
Wind Load Calculation – Orgadata Helpdesk EN
Other national standards follow the same input and setting principles. The wind zone is either determined directly or by selecting a dni. Wind pressure is positive, wind suction negative. Alternatively to the calculation in compliance with DIN The horizontal wind load on vertical constructions are either calculated according to different national standards or free values are applied.
This also applies here: TRLV are displayed automatically. It is up to the user to determine the units of wind pressure and stress displayed in the program and on printouts. It is up to the user to request these values from the glass manufacturer and to enter them afterwards.
Besides enter the dimensions of the cuboid, i.
The following paragraphs describe exemplary how to proceed in compliance with the allowed methods of the current DIN